Contract · Federal · Small Business Set Aside - Total

USCGC Stratton Shaft Alignment and Bearing Reaction Check

Agency: HOMELAND SECURITY, DEPARTMENT OF / US COAST GUARD
Location: Alameda, CA
Amount: Amount not listed
Posted: Sep 14, 2026
Set-aside: Small Business Set Aside - Total
NAICS code: 811310 look up NAICS codes
PSC code: J028

Timeline

Posted

Sep 14, 2026
Status

Closing soon

What contracts like this typically pay

No award history yet for this category (NAICS 811310).

What this contract is for

Agency: HOMELAND SECURITY, DEPARTMENT OF / US COAST GUARD
Location: Alameda, CA
Set-aside: Small Business Set Aside - Total
NAICS: 811310
Scope: Federal

Statement of Work CGC Stratton Shaft Alignment and Bearing Reaction Check Intent: contractor must measure and report to USCG the Vertical and Horizontal Loads on the (2) bull gear bearings and (2) intermediate bearings, stern and strut bearings, using the Strain Gage Method.

Period of Performance: 01 November 2026 – 01 January 2027 Location: USCGC Stratton, 42 Eagle Road Coast Guard Island, Alameda CA 94501 Contractor will install a total of (5) full bridge strain gage sets on the Port shaft, and (5) strain gage sets on the Starboard shaft, to complete the bearing load calculations.

Contractor will also measure and report the vertical load on each line shaft bearing using the Hydraulic Jack/Load Cell method.

Contractor will provide all specialty tools and calibrated instrumentation necessary to install the strain gages and measure the strain gage data.

Contractor shall provide a final written report within 15 days after completion of the work covered by this scope of work.

The report shall contain at a minimum the following: Introduction and References Project description Alignment calculations Alignment tests with strain gages Conclusions Recommendation for future action Data sheets on shaft model used to obtain reported results e.g. stations, strain gauge locations, diameters, lengths, load points, etc.

Data sheets from Computer runs that computed reported results e.g. stations, deflections, stresses, bearing reactions, slopes, etc.

References: Coast Guard Drawings Coast Guard Drawing 750 WMSL 114-001, Rev B, Fairwaters and Rope Guard Installation Details & L/M (ASC114001) Coast Guard Drawing 750 WMSL 243-007, Rev E, Propulsion Shafting System Arrangement (ASC243008) Coast Guard Drawing 750 WMSL 243-008, Rev -, Propulsion Shafting and Appendage (ASC243001B) Coast Guard Drawi...

Official solicitation and documents

The full solicitation, any attachments, and the actual submission instructions live on the official listing, not on this page. Oppward summarizes public record data; it does not host or mirror the source documents.

View the official listing on SAM.gov

Oppward is an independent service and is not affiliated with, endorsed by, or sponsored by SAM.gov or any government agency. This page is a plain-English summary of public record data; the linked source above is the authoritative listing.

How to bid on this

This is a contract solicitation, not a grant. To bid, you submit a proposal (usually a price and a description of how you would do the work) directly to the government, through the channel the official listing specifies, not through Oppward.

Make sure your business has an active SAM.gov registration. You cannot be paid on a federal contract without one.
Read the full solicitation on the official listing above, especially the scope of work, not just this summary. Our guide to reading a solicitation walks through what to look for.
Check the set-aside listed above and confirm your business actually qualifies for it before you spend time on a proposal. See our guide to set-asides if the category is unfamiliar.
Submit your proposal by the deadline, using the exact submission method the official listing states. A technically on-time bid sent the wrong way is often treated as late.