Contract · Total Small Business Set-Aside (FAR 19.5)

4310--Replacement Medical Air Equipment Grand Junction, CO

Agency: VETERANS AFFAIRS, DEPARTMENT OF / VETERANS AFFAIRS, DEPARTMENT OF
Location: Grand Junction, CO
Amount: Amount not listed
Deadline: Closes in 4 days (Jul 22, 2026)
Posted: Jul 15, 2026
Set-aside: Total Small Business Set-Aside (FAR 19.5)
NAICS code: 333912

What this contract is for

Amendment 001 to Solicitation #36C25926Q0523 (Replacement Medical Air Equipment) This amendment s purpose is to list and answer the questions submitted by the questions deadline as specified in the solicitation. Questions and Answers: Desiccant Dryer / Medical Air Load Calculation: The scope states that the desiccant air dryer shall be sized for the calculated system demand. Can the Government provide the existing or required medical air load calculation? Also, please confirm the required dryer dew point, or whether the system should be sized to the standard NFPA 99 medical air dew point requirement.Â No, you will have to do the calculations.Â See Plumbing PG-18-10 paragraph 8.2.3.2(k). Seismic Certification The solicitation specifically identifies OSHPD Seismic Certification for the medical vacuum pump system. Please confirm whether OSHPD Seismic Certification is also required for the medical air compressor system.Â No, it is not. Site Access / Rigging / Equipment Placement Can the Government provide any available photos, drawings, or layout information for the mechanical room and the equipment delivery path? Specifically, we are requesting door widths, corridor widths, elevator information if applicable, and any known rigging or access limitations. Please also confirm whether the new equipment is expected to be installed in the same footprint/location as the existing equipment.Â As available, however we request that you complete a site survey. Existing Piping and Electrical Tie-Ins Can the Government provide any available as-built drawings, photos, or additional information showing the existing medical air and medical vacuum piping connection points, electrical panels, disconnects, and tie-in locations?Â As available, however we request that you complete a site survey...

View the official listing on SAM.gov

Oppward is an independent service and is not affiliated with, endorsed by, or sponsored by SAM.gov or any government agency. This page is a plain-English summary of public record data; the linked source above is the authoritative listing.

How to bid on this

This is a contract solicitation, not a grant. To bid, you submit a proposal (usually a price and a description of how you would do the work) directly to the government, through the channel the official listing specifies, not through Oppward.

Make sure your business has an active SAM.gov registration. You cannot be paid on a federal contract without one.
Read the full solicitation on the official listing above, especially the scope of work, not just this summary. Our guide to reading a solicitation walks through what to look for.
Check the set-aside listed above and confirm your business actually qualifies for it before you spend time on a proposal. See our guide to set-asides if the category is unfamiliar.
Submit your proposal by the deadline, using the exact submission method the official listing states. A technically on-time bid sent the wrong way is often treated as late.